General Operational Overview
The Tie-FenLock 200 system is presented on a point setting panel to the user. Indications of the current position of the point machine, normal or reverse, are shown with LEDs. Points are operated by pressing a single button corresponding to a single point end.
It is possible to fit multiple point setting panels. However, as there is no interlocking it is important that procedures are in place that do not allow two users to operate the points concurrently.
Example of Operation
The operation of the point setting panel is as follows:
The user approaches the panel and presses the buttons until the point ends intended for use are in their correct position.
The user checks that the end position LED indication of each point end is in the correct lie and that the indication is steady, not flashing.
After this, the user may direct the driver to the intended destination using hand signalling and verbal communication.
Whatever your signalling or telecoms requirements may be, Fenix Rail Systems has the railway industry experience and expertise to make your project a success.
18 Shottery Brook Office Park
Timothy’s Bridge Road
T: 03300 580180
T: 01926 358428
Subscribe to The Signal Box Newsletter!